PURSUIT DENALI 24, Руководство пользователя

Страница: 43 / 132

Denali 24
Note: Please refer to the DANGER and CAUTION notations in the Ventilation Systems
Chapter 8.
Bilge Pump
The bilge pump is installed in the center of the bilge below the engine. The pump moves water out
through the thru-hull fittings near the transom. To start the pump manually, put the switch in the
“ON” position.
Note: The bilge pump will start automatically when there is sufficient water in the bilge
to activate the float switch. The float switch is protected by a circuit breaker located
near the battery selector switch and is always supplied current when the batteries are
connected.
Anchor/Nav Lights
The switch is a three-position switch. The middle position is “OFF.” Moving the switch in one
direction will activate the navigation lights. Moving the switch in the opposite direction activates
the anchor light.
Cockpit Lights
Activates the lights that illuminate the cockpit area.
Panel Lights
Activates the engine gauge and compass lights.
Wiper
Activates the windshield wipers.
Cabin Lights
Activates the lights in the cuddy cabin.
Livewell Switch
This switch activates the baitwell circulating pump that supplies water to the baitwell.
Washdown Pump
This switch activates the raw water washdown pump. The pump is the pressure demand type and
is protected by a circuit breaker in the panel and an automatically resetting breaker on the pump
motor.
Note: Please refer to Chapter 6 for more information on the baitwell and washdown
systems.
Freshwater
Activates the freshwater pump pressure switch located on the pump. The pressure switch
automatically controls the water pump when the system is activated and properly primed. It is
protected by a circuit breaker in the panel and an automatically resetting breaker on the pump motor.
4-3