PURSUIT DENALI 24, Руководство пользователя

Страница: 95 / 132

Denali 24
13-1
Chapter 13:
ROUTINE MAINTENANCE
13.1 Exterior Hull and Deck
Hull Cleaning-Below The Water Line
When the boat is removed from the water, clean the outer bottom surface immediately. Algae,
grass, dirt and other marine growth is easier to remove while the hull is still wet. Use a pressure
cleaner or a hard bristle brush to clean the surface.
If the hull bottom has been painted with antifouling paint, contact your dealer for the recommended
maintenance procedures.
Bottom Painting
If the boat is to be left in saltwater for extended periods, the hull must be protected from marine
growth by antifouling paint. Because of variations in water temperature, marine growth, and
pollution in different regions, your dealer and/or a qualified boat yard in your area should be
consulted when deciding what bottom paint system to apply to your hull. This is extremely
important as pollution and marine growth can damage fiberglass hulls.
SANDING OR SANDBLASTING THE HULL BOTTOM WILL DAMAGE THE FIBERGLASS.
USE ONLY STANDARD ANTIFOULING PAINTS AND FIBERGLASS WAX REMOVERS AND
PRIMERS RECOMMENDED BY THE ANTIFOULING PAINT MANUFACTURER WHEN PRE-
PARING THE HULL FOR BOTTOM PAINT. SANDING OR SANDBLASTING AND THE USE
OF A COATING OTHER THAN STANDARD ANTIFOULING PAINT OR EPOXY BARRIER
COATINGS ARE NOT RECOMMENDED AND WILL VOID THE FIVE YEAR HULL BLISTER
WARRANTY.
Do not allow the hull antifouling paint to contact the outdrive. Most antifouling paints designed for hull
bottoms contain copper and can cause severe damage to the outdrive. Always leave a 1/2" barrior
between the hull bottom paint and outdrive.
Most bottom paints require some maintenance. Proper maintenance is especially important when
the boat is in saltwater and not used for extended periods or after dry storage. If the hull bottom
has been painted with antifouling paint, contact your dealer for the recommended maintenance
procedures.
Zincs
Sacrificial anodes are installed on the outdrive units and should be installed on the trim tabs if the
boat is to be left in the water. Contact your dealer for the proper size and type of anodes to be used
and the specific installation procedure. Anodes should be checked monthly and changed when