Pulsafeeder Pulsalube 8 GS Ultra, Руководство по эксплуатации и техническому обслуживанию

Страница: 136 / 198

STORAGE & COMMISSIONING
RETAIN FOR FUTURE USE
1. Storage
IMPORTANT NOTE
For storage periods longer than 9 months, or for storage
in less than desirable conditions, please consult NORD for
recommendations.
Storage for up to 9 months is possible, so long as the follow-
ing conditions are observed:
• Store the gear unit in its actual mounting position in
accordance with the specified oil fill-level, in a clean and
dry temperature controlled area. Avoid temperature
fluctuations within the range of 0°C and 40°C (32°F to
104°F) and avoid relative humidity conditions in excess
of 60%.
• Protect all exposed or unpainted shaft and flange surfaces
with an anti-corrosion agent or grease.
• Store in a location free from shock and vibration, to avoid
false brinelling of bearing elements and raceways.
• Whenever possible, rotate the shafts periodically, by hand
if necessary, to help prevent brinelling (bearing damage)
and to help keep the shaft seals pliable.
• Avoid direct exposure to the sun or UV light and aggressive
or corrosive materials in the environment (ozone, gases,
solvents, acids, caustic solutions, salts, radioactivity, etc.
2. Commissioning
Prior to gear unit start-up, complete the following:
• Please check your gear unit for a vent and if applicable to
your product, remove the sealing plug to activate.
WARNING
To prevent build-up of excessive pressure, sealed vents
must be activated as shown prior to gear unit start up.
Sealed vent Activated vent
• Check the lubricant and be sure the gear unit is filled with
the proper oil type, to the proper level, as determined by
the mounting position.
IMPORTANT NOTE
Some smaller gear units are supplied as maintenance free/
lubricated for life gear units. Oil level may not be checked
on some of these units.
• Check the condition of all shaft seals and all assembled
flange gasket areas. If any change is detected in the
shape, color, hardness or permeability, or if any leaks are
detected, the corresponding shaft seals and/or gaskets
must be replaced.
• Remove all anti-corrosive metal protectant from
otherwise bare metal surfaces. Follow product manufac-
turers directions and warnings during surface protection
removal.
• Check the resistance of all motor and brake windings to
verify the integrity of the winding insulation and inspect
all terminal box openings and wire connection areas to
verify that all components are dry and free of corrosion.
U10040 - 1 of 2
www.nord.com/docs 03.31.2016
NORD Gear Corporation
Toll Free in the United States: 888.314.6673
NORD Gear Limited
Toll Free in Canada: 800.668.4378