Pulsafeeder Pulsalube 8 GS Ultra, Руководство по эксплуатации и техническому обслуживанию

Страница: 84 / 198

9
Dismantling / Reassembly
Ausgabe
issue
C / 17.03.2006
Dokument
document
OM.HBD.01e
Blatt
sheet
2 (2)
Incorrect
9.3.5 Cant up the holding band
9.3.6 Shear the holding band (material: 1.4301; 1.4571)
9.3.7 Check the holding band after assembly
The holding band (HBD) is too tight, univer-
sal joint sleeve will be damaged/sheared off.
HBD
¾ Swivel mounting tool (W3) approx. 60° up-
wards.
¾ Loosen crank (KU) by a half turn.
¾ Swivel cutting lever (SH) forward until the
pressure piece is lying behind the holding
band loop (SCL).
KU
SH
ca
. 6
0°
SCL
¾ Hit the cutting lever (SH) with the inside of
your hand.
– Cant up and shear the end of the
holding band behind the loop (SCL).
– Carefully straighten up the holding
band if it rises up on the sheared side.
NOTICE
Universal joint sleeve damage.
Pin joint grease can emerge.
¾ Avoid hammering or knocking.
SCL HBD
¾ The holding band must lie in the groove of
the universal joint sleeve.
¾ Replace the holding band if the holding
band slips back through the loop.
SCL HBD