Pulsafeeder Pulsalube 8 GS Ultra, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 198

Safety Data Sheet
pulsa.com
______________________________________________________________________________________________________________________
4 | P a g e
Water spill and land spill recommendations are based on the most likely spill scenario for this material;
however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current direction
and speed may greatly influence the appropriate action to be taken. For this reason, local experts should be
consulted. Note: Local regulations may prescribe or limit action to be taken.
ENVIRONMENTAL PRECAUTIONS
Large Spills: Dyke far ahead of liquid spill for later recovery and disposal. Prevent entry into waterways,
sewers, basements or confined areas.
SECTION 7 HANDLING AND STORAGE
HANDLING
Prevent small spills and leakage to avoid slip hazard. Material can accumulate static charges which may cause
an electrical spark (ignition source). When the material is handled in bulk, an electrical spark could ignite any
flammable vapors from liquids or residues that may be present (e.g., during switch-loading operations). Use
proper bonding and/or earthing procedures. However, bonding and earthing may not eliminate the hazard from
static accumulation. Consult local applicable standards for guidance. Additional references include American
Petroleum Institute 2003 (Protection Against Ignitions Arising out of Static, Lightning and Stray Currents) or
National Fire Protection Agency 77 (Recommended Practice on Static Electricity) or CENELEC CLC/TR 50404
(Electrostatics - Code of practice for the avoidance of hazards due to static electricity).
Static Accumulator:
This material is a static accumulator.
STORAGE
The type of container used to store the material may affect static accumulation and dissipation. Do not store in open or
unlabelled containers. Keep away from incompatible materials.
Material is defined under the National Standard [NOHSC:1015] Storage and Handling of Workplace Dangerous Goods.
SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure limits/standards for materials that can be formed when handling this product:
NOTE: Limits/standards shown for guidance only. Follow applicable regulations.
Biological limits
No biological limits allocated.
ENGINEERING CONTROLS
The level of protection and types of controls necessary will vary depending upon potential exposure conditions.
Control measures to consider:
No special requirements under ordinary conditions of use and with adequate ventilation.
PERSONAL PROTECTION
Personal protective equipment selections vary based on potential exposure conditions such as applications,