1.2: Open bag 19, take the second Gear Box back piece And mount the two plastic pieces –Susp.
Holders- from bag 19 onto the Gear Box back piece as shown in picture, using the screws included.
The larger plastic piece is to be used above driveshaft
with Screws 3*25 while the smaller plastic piece is to
be used bellow driveshaft. Place the small white
bushings in corresponding holes on the upper Susp.
Holder, make sure the hole in the bushing is pointed
down. This is the Front Gearbox Assembly. Notice in
the picture how parts are facing, this is important for
later!
1.3: Open bag 9 containing the metal Chassis and a small bag of screws. It is advised to keep most of
the screws in the bag for now, removing only the ones you need for each step. Take 4 of the Self-
tapping screws 3*16, in order to mount both Gear Box back pieces onto the Chassis plate. You will
see on each end of the Chassis 6 holes. Center two
holes are for register pins under the Gear Box piece,
and remaining 4 are for screws. You will also notice
one end of the Chassis angles upwards; this is the
front. Place the Gear Box from step 1.2 on the front
and position correctly ensuring pins snap into the
register holes, then fasten with screws 3*16 as shown
in picture. Repeat for the rear Gear Box.
1.4: Now to place Diff. Gear Sets inside the Gear Box. It is very important that both face correctly!
When the open Gear Box is facing you, the large gear
of the Diff. Set should face to the left, as shown in
picture. This is true for both front and rear, but only if
the Gear Box is facing you! Now place the front part of
the Gear Boxes over the Diff. Set and push into the
register pins. You should hear a click once the parts
are in place.
Keep safe remaining parts for an upcoming step.
