6.0: Front Wheel Steering
Youtube guide for this stage:
Requires following bags:
8:
60017 Front Wheel Hub Carrier
60018 Steering Hub Carrier
60042 Steering Shaft Bush Ø5.8
61022 Ball Head Mech Screw 3*11
85711 Wheel Hex + Nuts
85763 Bearings 16*8*5
60031 Front Universal Drive Joint from bag 11 opened in step 3.2.
6.1: From bag 8, start by pushing a Ball Bearing 16*8*5 -85763- into each side of the Steering Hub -
60018-. Some force may be required, but ensure they are
flat and level in relation to the Steering Hub first, so that no
parts are damaged. From bag 11, push the front Universal
Drive Joint -85763- through the Bearings and rotate parts to
ensure a secure fit.
6.2: Now place the Wheel Hex -85711- on the end of the
Drive Joint, line up the register holes properly and then push
through the steel pin to secure both parts. This may require
considerable force, but again ensure holes are lined up
properly and all parts are level in relation to each other. Be
careful to not damage any parts. Rotate parts to ensure a
nice fit, and use washers if needed.
6.3: Place a Steering Shaft Bush Ø5.8 -60042- into the suitably sized holes on the Hub Carrier -60018-
from the inside, as pictured. Then place the Dogbone of the Steering Hub Assembly through the large
hole in the Hub Carrier, line up the holes with the Bushings and secure using Ball Head Mech Screw
3*11 -61022-. Take careful notice of relation of parts to each other in the pictures, both sides are
mirrored versions of each other.
