3.3: The Center Diff. holders each have a slot for the
Ball Bearing on the Center Diff. to fit into. Mount
them, and then fasten the top plate onto the holders
using the Self-tapping Screws 3*12. Note that on one
side the Antenna Mount should be fastened, notice
the relation of parts in the picture. Use the Spacers
included if needed.
3.4: When placing the Center Diff. Assembly onto the Chassis, you must at the same time position the
Center Dogbones. The large gear on the Diff should face to the rear of the model, and the short
Dogbone goes towards the Rear, while the long Dogbone goes towards the Front. Make sure they
slot into the Drive Cups on both ends and then place the Center Diff. Asembly into the center of the
model, one holder on each side of the rectangular hole in the middle, and making sure register pins
are in their holes. Fasten using 4 Self-tapping Screw 3*10 from bag 9. Notice how all parts are
mounted in the picture, and see video for live construction.
3.5: Open bag 14 and mount the Battery Case behind the Servo using the remaining two Self-tapping
Screws 3*10 from bag 9.
