PRONAR T185/1, Руководство пользователя, Страница: 96 / 156

Rozdział 4 Terms of use
4.30
PRONAR T185/1
4.9 UNLOADING
The unloading of materials in the con-
tainer is done by tipping the container
backwards. The trailer is unloaded in the
following order:
• The tractor and trailer should be
placed for straight ahead on flat, level
and hard ground.
• Immobilize tractor and trailer with
parking brake.
• Extend the suspension interlock
cylinders.
• Insert the rear bumper of the trailer as
far as possible and secure it against
sliding.
• Open the rear wall of the container
and secure it against accidental
closing.
Be particularly careful when
opening, as the load can put
a lot of pressure on the wall that
you are opening.
• Switch the trailer to the „tipper”
function. Correct switching will be si-
gnaled by a lamp next to the dumper
symbol. In this function, the container
lock will lock the container (optional
for hydraulic function switching with
container lock).
In a system with manual hook
lift/tipper switch, pull back the
locking bolt (2) and put the lever
(1) in position (I) „tipper” - Figure
(4.23).
• Raise the swing frame with the con-
tainer and unload the container.
Tipping may only be carried out when the trailer is
connected to the tractor.
It is forbidden to tilt the container during strong gusts
of wind.
It is forbidden to start or drive with a raised container.
Use extreme caution when working near power lines.
Take care when opening container closures, due to
pressing the load on the walls.
Be careful when closing the container wall to avo-
id crushing your fingers. Make sure that during un-
loading nobody is near the tilted container and the
falling load.
I
622-H.23-1
1
2
Figure 4.23 Setting the trailer’s operating mode
(1) lever (2) interlock