PRONAR T185/1, Руководство пользователя, Страница: 69 / 156

Rozdział 4
4.3
PRONAR T185/1
Terms of use
MECHANICAL SUPPORT
LIFTING
• Push the crank (4) in direction (A) -
low gear.
• Turn the crank in the direction (C) -
counter clockwise to raise the support
foot from position (D) to (E).
• If the foot loses contact with the
ground, the support transmission can
be shifted to a higher gear.
To do this, pull the crank in the
direction (B).
• Turn the bolt (6) with the handle
upwards and slide it out of the tele-
scope (2).
• Raise the support foot to the up-
permost position (F) by holding the
handle (7).
• Insert the pin and secure it.
Remember! The pin bolt must
be between the plate and the
telescope. LOWERING
• Hold the support foot by the handle
(7) and remove the bolt (6).
DANGER
Be careful because of the risk of feet crushing.
CAUTION
Remember that the gear’s high gear - position (B) of
the crank is only intended for supporting the support
if the foot is unloaded. Use this gear only when the
foot is not resting on the ground.
D
E
F
A
B
C
F
FF
622-H.02-1
6
4
7
5
1
3
2
Figure 4.2 Mechanical support
(1) support foot (2) telescope
(3) body (4) crank
(5) spring pin
(6) bolt
(7) a holder