Page 44
No. of Markings Filter
Number of expected markings, value taken from the current Marking Preset, see
chapter 5.8.1 on page 37. Default = 1
DayContrastFilter
Calculation of day contrast ratio.
•
DayContrast:
Enable / disable filter
•
ToleranceBandFromB.: Tolerance band in %, default = 10
Contrast Filter
Calculation of day contrast ratio.
•
Contrast Threshold:
Enable / disable filter
•
Contrast Threshold.:
Contrast threshold, default = 2
OffsetDifferenceFilter
Internal filter, do not change
AverageFilterSettings
Filter settings for average calculation of R
L
(R
L
DB).
•
PercentPassedMin.:
Min percentage of measurements within an interval
that must have passed all filters, default = 10
•
CutFromTopForMean%: Percentage of the highest measurements to be
eliminated (noise reduction), default = 2
•
TakeForMeanFromTop%: Percentage of measurements (counted from top) to
be included in average calculation, default = 20
•
RemovePeaksForMinMax: Enable / disable removal of peaks
CamTrigger
Filter settings for automatic camera triggering. Values taken from the current
Marking Preset, see chapter 5.8.1 on page 37.
•
EnableAutoCamTrigger: Enable / disable filter
•
CamTriggerMin:
Takes a picture if R
L
is lower, default = 100
•
CamTriggerMax:
Takes a picture if R
L
is higher, default = 1000
Msre & RT Monitor
Important system parameters like lamp voltage, signal quality and vehicle speed are
shown. Click on the “Msre & RT Monitor“ tab in the system configuration window:
