26
Chapter
1
Setting Up The Printer
Installation
The following sections will guide you through the installation of the printer.
1.
Place the printer in a suitable location on a flat level surface that allows
easy access to all sides of the printer.
CAUTION
The printer should never be operated while resting on its side or upside
down.
2.
Check that the printer power switch is in the OFF (O) position.
WARNING
Failure to properly ground the printer may result in electric shock to the
operator.
In compliance with international safety standards this printer has been
equipped with a three-pronged power cord. When inserted in a correctly
wired power outlet the ground conductor will ensure that the printer
chassis is at ground (earth) potential. Do not use adapter plugs or
remove the grounding prong from the cable plug. If an extension cord is
required, ensure that a three-wire cable with a properly grounded plug is
used.
3.
Attach the AC power cord to the AC power receptacle in the back of the
printer.
CAUTION
Verify the required voltage on the printer’s model number label on the
rear of the printer.
4.
Attach the AC power cord to a grounded (three prong) electrical outlet of
the proper voltage.
Содержание T5000 Series
