PREVOST LE MIRAGE XLII BUS SHELLS, Руководство по обслуживанию

Страница: 857 / 1260

Section 18: BODY
PA1564
53
5. Check that the doors swing freely and close
properly. It may be necessary to adjust the
door latch to get proper fit and operation.
To adjust the latch mechanism (4, Fig. 56) and
the striker pin:
1. Open the doors to access the striker pin.
2. Slightly loosen the striker pin.
3. Using a hammer, adjust the striker pin to
center it in the door latch mechanism.
4. Tighten the striker pin.
5. Check doors fit and operation.
FIGURE 56: ENGINE COMPARTMENT DOORS
18633
™ Engine Compartment Door Body Panel
Removal
For the removal of engine compartment door
body panel, you will need:
Pneumatic “Zip gun” type tool;
Razor sharp window scraper;
A pair of locking pliers;
Isopropyl alcohol.
o
Remove damaged engine compartment
door from vehicle.
o
Install the damaged door onto an
appropriate support.
o
Wearing gloves, goggles and ear plugs, pry
loose body panel using a “Zip gun” or lever
starting from the edge opposite the curved
side.
o
Use the “Zip gun” to detach completely the
stainless steel body panel from door frame.
CAUTION
Do not damage painted surface.
o
Use a second person equipped with a pair
of locking pliers to pull the body panel as
you cut the Sika bead.
WARNING
Be very careful when pulling the body panel,
somebody could get hurt if the body panel
suddenly detach from the door surface without
notice.
o
Using the window scraper, remove any Sika
bead or self adhesive tape residue left on
the fiber glass surface.
For gluing of engine compartment doors
molding, refer to procedure
SAV00211 included
at the end of this section.
For engine compartment door body panel
installation, refer to procedure
SAV280032
included at the end of this section.
7.3.3 Rear Bumper
Remove three bolts on each side holding
bumper to vehicle and remove bumper.
To install bumper, reverse the procedure.
FIGURE 57: REAR BUMPER