PREVOST LE MIRAGE XLII BUS SHELLS, Руководство по обслуживанию

Страница: 365 / 1260

Section 12: BRAKE AND AIR SYSTEM
PA1564
7
5. ACCESSORY AIR FILTER
FIGURE 4: ACCESSORY AIR FILTER
12088
This filter is located inside the front service
compartment (Fig. 3). Its main function consists
in filtering the air supplied to the accessory air
system, when connected to an external supply
line. Ensure filter is purged whenever supplying
the system with an external air line and at least
every 12,500 miles (20 000 km). To purge, open
drain valve (Fig. 4), let the moisture come out,
then close the drain valve.
5.1 FILTER ELEMENT REPLACEMENT
Replace filter element whichever of the following
occurs first: every 100,000 miles (160 000 km),
every two years, or whenever differential
pressure exceeds 15 psi (105 kPa) between
filter inlet and outlet ports. Check condition of all
three O’rings for damage. Replace when
necessary (Fig. 4).
5.2 CLEANING
Clean filter body and bowl with a warm water
and soap solution. Rinse thoroughly with clean
water. Blow dry with compressed air making
sure the air stream is moisture free and clean.
Pay particular attention to the internal passages.
Inspect all parts for damage and replace if
necessary.
6. AIR GAUGES (PRIMARY, SECONDARY
AND ACCESSORY)
The air pressure gauges, located on the
dashboard (see
“Owner’s Manual” ), are
connected to the DC-4 double check valve,
located on the pneumatic accessory panel in the
front service compartment.
The latter is connected to the air lines running
from the primary and secondary air tanks, as
shown on the pneumatic system diagram
provided in the technical publications box. The
accessory air gauge is connected to the
accessory air tank using the drain valve
connector. The vehicle should never be set in
motion until the buzzer alarm and warning lights
turn off, i.e. when air pressure registers at least
66 psi (455 kPa). Moreover, if pressure drops
below 66 psi (455 kPa), the
"Low air pressure"
warning lights will turn on, and the "Low air
pressure" buzzer will sound. Stop the vehicle
immediately, determine and correct the cause(s)
of pressure loss. Check the gauges regularly
with an accurate test gauge. Replace the gauge
with a new unit if there is a difference of 4 psi
(27 kPa) or more in the reading.
7. AIR FILTER/DRYER
FIGURE 5: HALDEX AIR FILTER DRYER
12194
The air filter/dryer is located in front of rear
wheelhousing above drive axle (Fig. 1 & 5). Its
purpose is to remove moisture that could
damage the air system before the air enters the
system reservoir. The air filter/dryer also filters
the air to remove dirt, compressor oil, and other
contaminants that can damage the system.