PREVOST LE MIRAGE XLII BUS SHELLS, Руководство по обслуживанию

Страница: 855 / 1260

Section 18: BODY
PA1564
51
7.2 ZONE 2
FIGURE 54: ZONE 2
7.2.1 Upper Side Panel
For structure preparation, refer to procedure
SAV00035 included at the end of this section.
For installation of upper side panel neoprene
foam tapes, refer to procedure
SAV00036
included at the end of this section.
For installation of upper side panel, refer to
procedure
SAV00041 included at the end of this
section.
7.2.2 Fixed Windows
Depending on the method chosen for fixed side
window removal or installation, you may need:
*
Drill equipped with a sharp pointed rod into
which a small hole was drilled;
* Razor sharp window scraper;
* Braided windshield wire and a pair of
handles;
*
Gloves, goggles or face shield.
Fixed Window Removal
1
st
Method
NOTE
This method is used only in the case of a
regular fixed side window. For the fixed upper
portion of awning or sliding windows, you must
use method number 2.
o
Apply a sticky plastic film onto all of
window outside surface for safety reason.
o
Using a drill equipped with the special
sharp pointed rod, drill through the window
seal into one of the bottom corners, from a
30º angle with reference to the vehicle.
o
This procedure requires accuracy and it is
possible not to succeed on the first at-
tempt. From the inside of vehicle, a sec-
ond person ensures the rod passes
through.
o
Remove the rod; thread the wire into the
small hole. Reinsert the rod and the wire
into the hole far enough so that the person
inside the vehicle can pull the rod using a
pair of pliers.
o
Attach the wire ends to the specially
designed handles.
o
Pull in turn from the inside and the outside
of vehicle to gradually cut the Sika bead
on the window perimeter.
o
When you reach top corner, detach wire
from the outside handle, secure it to a fish
wire or rod and thread it underneath the
aluminum molding behind the rivets.
o
Detach wire from fish wire and continue
cutting using the handle.
o
Cut Sika bead until you come back to
starting point, then you can remove the
window by carefully pushing it out from the
inside of vehicle.
2
nd
Method
o
Apply a sticky plastic film onto all of
window outside surface.
o
To limit as much damage as possible,
remove any interior molding in the way.
Install a plastic film on the window interior
surface and secure using masking tape
onto all of window perimeter.
NOTE
Do not stretch plastic film and leave enough
play to be able to push window out without
tearing the plastic film.