PREVOST LE MIRAGE XLII BUS SHELLS, Руководство по обслуживанию

Страница: 1011 / 1260

PROCEDURE NO: SAV280020
REVISION 14
Page 15 of 18
Interior Finishing Panel Installation
A) Unscrew lock guide.
B) Install finishing panel and fasten guide on top
of panel using screws.
C) Drill 8- 1/8" dia. holes and fasten panel using
screws.
4.82
D) Drill 1- 5/32” dia. hole
Closing Plate Installation
A) Clean using anti-silicone.
(See SAV000001, Section A)
B) Affix 1/16 x 1/2 foam tape 2mm from edge of
plate. Also, affix 2 pieces of foam tape 1/8 x
1/2.
4.85
C) Position plate onto the door. Drill 9-
7/64" dia.
holes and fasten plate using screws.
Installation of Window Interior Finishing Molding
A) Position plastic molding onto the door frame to
check for proper fit.
Note: If it does not fit properly, grind the radius.
B) Clean the area where the double-face self
adhesive tape will be applied using anti-
silicone.
(See SAV000001, Section A)
C) Affix some double-face self adhesive tape 1/16
x 3/8.
Note: Peel back of self-adhesive tape at each
end to be able to screw in the “Norryl” molding
and then peel the back of the tape afterwards.
D) Position Norryl molding even with top of door
frame.
4.87
E) Drill 4-
1/8’’ dia. holes & fasten using screws.
FOAM TAPE
DRILL 5/32’’
GRING HERE