PREVOST LE MIRAGE XLII BUS SHELLS, Руководство по обслуживанию

Страница: 856 / 1260

Section 18: BODY
PA1564
52
o
Using a ball peen hammer, hit one of the
window bottom corners from the outside .
o
Carefully push window out and lift it up
sufficiently to separate it from the alumi-
num molding.
o
Attach the windshield wire to a fish wire
and thread it underneath the aluminum
molding behind the rivets.
o
Detach wire from fish wire and continue
cutting using the handle.
o
Make a notch at each window top corner
to make sure you pass underneath the
remaining pieces of glass.
o
Remove the aluminum molding and clean
up the frame using the window scraper.
For gluing of lateral fixed half-window, refer to
procedure
SAV00045 included at the end of this
section.
For the installation of awning or sliding window,
refer to procedure
SAV00038 included at the
end of this section.
For gluing of lateral fixed window, refer to
various procedures:
SAV00037 for g
luing vertical
and bottom rubber seals
; SAV00043 for the
installation of lateral fixed window and
SAV00044 for making the Simson joint around
fixed windows.
All these procedures are included at the end of
this section.
7.2.3 Electric Awning Windows
For window or components replacement, refer to
paragraph 6.2.3.
7.2.4 Electric Sliding Windows
For sash removal or replacement, refer to
paragraph 6.2.4.
7.3 ZONE 3
FIGURE 55: ZONE 3
7.3.1 Rear Cap
The fiberglass rear cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, make an appointment at a Prévost
service center near you.
For minor damages, refer to Paragraph 4
"Common Fiberglass Repair Procedure" and
Paragraph 5 "Common Painting Procedure".
7.3.2 Engine Compartment Doors
™ Engine Compartment Doors Adjustment
Engine compartment doors may be adjusted for
proper fit by untightening hinge bolts:
1. Loosen the bolts, (1, 2 Fig. 56) holding the
hinge to the vehicle structure to shift the
door "UP or DOWN".
2. Loosening the bolts (3, Fig. 56) allows the
door to be shifted "LEFT or RIGHT" and "IN
or OUT".
3. Adjust the doors position depending on the
gap needed between exterior finishing
panels.
4. Tighten the bolts.