Precor EFX 825, Руководство по обслуживанию

Страница: 139 / 171

EFX 885, 835, 825
Service Manual 20039-166
Page 139
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
12. Remove the nut retaining the external power supply input jack. Refer to Diagram 10.1.1
13. Remove the external power supply input jack from the cover.
14. Remove the four screws (2 each side) that fasten the cover to the frame. Slide the two wire clips off of the
t side. Remove the cover from the EFX.
15. Set the replacement cover in its mounting position and fasten it with the screws removed in step 12. Slide
the two wire clips into place on the covers left side.
16. Set the external power supply input jack at its mounting location and fasten it with the nut removed in step
10.
17. Replace the left and right side covers as described above.
Replacing the Front Section of the Rear Cover
18. Remove the left and right side covers as described above.
19. Remove the top section of the cover as described above.
20. Remove the four screws that fasten the rear cover section to the frame. Carefully slide the rear cover
section rearwards a couple of inches. to clear the overlap between the front and rear cover sections.
21. Remove the cables from the two lower cable clips on the inside of the front section of the cover.
22. Remove the two screws that fasten the lower PCA mounting bracket to the front section of the cover. Refer
to Diagram 10.1.2.
Diagram 10.1.2 - Lower PCA Mounting Bracket
23. Remove the lower PCA and bracket and carefully support it away from the front section of the cover.
24. Remove the small cover at the front portion of the cover section by sliding it forward and off of the front
section of the cover. Refer to Diagram 10.1.3. Remove the two cover mounting screws.
Mounting
Screw
Mounting
Bracket