Chapter 2 Installation
ADSD-S-S
13
●
The location without vibration and shock.
●
The location without high levels of electromagnetic radiation.
The ambient temperature of servo drive for long-term reliability should be within under -20 ~55 .
℃
℃
Install the product in a clean and dry location
1. When assembling control cabinet, avoiding the metal scraps dropping into servo driver
2. Keep dropping water , steam , dust or oil away from control cabinet and the fun of servo
drive.
3. If set the control panel at a place with corrosive gases or dust, should forced ventilation (into
control cabinet clean air, make the internal pressure is higher than the external pressure) to
prevent these material into the control cabinet.
2-4 Installation procedure and minimum clearances
Important Attentions:
Installation direction must be in accordance with the provisions, incorrect installation may
result in a drive malfunction. In order to ensure the drive is well ventilated, ensure that the all
ventilation holes are not obstructed and sufficient free space is given to the servo drive. Ac servo
drive when the installation, the air intake and exhaust vent can not be sealed, nor a horizontal
position, otherwise it will cause failure.
Installation Procedure:
In order to help the cooling fan subject to a lower wind block so as to dissipate the heat more
effectively, we suggest users to observe below minimum installation clearance.
Minimum Clearances:
Chapter 2 Installation
ADSD-S-S
14
50
mm(min)
50
mm(min)
20
mm(min)
20
mm(min)
100
mm(min)
100
mm(min)
20
mm(min)
10
mm(min)
10
mm(min)
10
mm(min)
100
mm(min)
100
mm(min)
40
mm(min)
FUN
FUN
