- 48 -
0900-GB_AUFBEREITER WECHSELN_3843
GB
REPLACE CONDITIONER
Operating Principle
The mower unit is compatible for optional hitching of a tine conditioner, roller conditioner or swath former. The conditioners
or swath formers are additionally designed as a safety device and are imperative for use.
Dismantle conditioner
1. Reduce relief pressure of mower unit
(A) Version: Hydraulic pressure relief
Reduce to the relief pressure to 0 on the operating
panel in the “SET” menu.
(B) Version: Mechanical pressure relief
Raise the mower unit until the pressure relief springs
are depressurized and open the linch pin.
(See
Section headed “Pressure relief and collision
lock”)
2. Remove protective cover and belt
Loosen the belt tension using the knife wrench (1) and
remove the belt (2) on the conditioner side.
Then remove knife wrench.
The belts must be removed completely if a swath former
is attached. Unhitch PTO drive shaft (3) and remove
belt.
3. Loosen conditioner fixing
The conditioner fixing (1) to be loosened is located
under the conditioner’s outer side guard.
The optimum alignment between mower unit and
conditioner is adjusted using the conditioner fixing (1).
The belt pulleys on the inside of the conditioner must be
aligned flush with the belt pulleys of the mower unit.
4. Attach chassis
Insert the chassis (1) supplied into the mounting on
both sides until the limit is reached for transporting
the dismantled conditioner.
278-09-19
B
A
3
2
1
1
1
Caution!
Danger
of
crushing! Re-
duce the relief
pressure prior to
dismantling the
conditioner or
swath former.
