Playnation Everest Extreme 1500MW, Инструкция по эксплуатации

Страница: 119 / 234

STEP 46: SLIDE POST INSTALLATION
1: PLACE THE END OF THE DECK SPACER AGAINST THE CORNER POST. THE OUTSIDE OF THE DECK
SPACER SHOULD BE FLUSH TO THE OUTSIDE OF THE CORNER POST. FASTEN THE DECK SPACER TO THE
DECK SUPPORT WITH #8 X 2" WOOD SCREWS.
2: MAKE THE DECK SPACER LEVEL WITH THE DECK BOARD BEHIND IT. DRIVE A 3/8" X 5" LAG SCREW WITH
3/8" WASHER THROUGH THE RAD RIDE CENTER POST INTO THE 4 X 4 X 70" UNDER DECK SUPPORT.
3: MEASURE THE BOTTOM OPENING AND RECORD THIS MEASUREMENT. MEASURE AT THE TOP OF THE
OPENING. MAKE THE TOP OF THE OPENING THE SAME AS THE MEASUREMENT YOU RECORDED. NOW USE
THE TOP HOLE IN THE RAD RIDE CENTER POST TO DRILL A 3/8" HOLE THROUGH THE 2 X 4 X 70" RAILING.
4: PLACE A T-NUT INTO THE HOLE IN THE RAILING. FASTEN THE RAD RIDE CENTER POST TO THE RAILING
WITH A 5/16" X 4-1/2" HEX BOLT AND 5/16" WASHER.
SHALLOW
COUNTERSUNK HOLE
AT TOP.
INSIDE VIEW
OF RAD RIDE
CENTER POST
5/16" WASHER
DRILL 3/8" HOLE
HEX BOLT
T-NUT
5/16" X 4-1/2"
WOOD
SCREWS
FLUSH TO OUTSIDE OF POST.)
3/8" WASHER
3/8" X 5" LAG SCREW
#8 X 2"
(END FLUSH TO POST, OUTSIDE
DECK SPACER ATTACHED
TO RAD RIDE CENTER POST
RAD RIDE
CENTER POST
109