piezosystemjena nano box USB, Инструкция по эксплуатации

Страница: 37 / 44

phone: +49 (3641) 66880 • fax: +49 (3641) 668866 • info@piezojena.com • http://www.piezojena.com
Appendix 34
9.1.1.22.6 Command: tbval
Command tbval,slew-rate,pos,duration
Description Set the parameters of the current row of the table-driven generator by storing them into the
device's EEPROM. On success, the index of the current row is incremented automatically.
The index of the current row of a running or stopped table-driven generator is affected, but the
rows of a running or stopped table-driven generator are not affected
Responses ok on success
nok on failure
Query tbval
Description Get the parameters of the current row of the table-driven generator by retrieving them from the
device's EEPROM. On success, the index of the current row is incremented automatically.
The index of the current row of a running or stopped table-driven generator is affected.
Responses tbval,slew-rate,pos,duration on success
nok on failure
Parameters Description Type: Range Default value
slew-rate Slew rate [V/µs] FPV: 0.000000003 ... 0.005 0.005
pos Position or voltage [%] FPV: 0 ... 100 0
duration Duration [s] FPV: 0.1 ... 100 0.1
Errors error-bit 28, error-bit 29, error-bit 30
Examples request: "tbval,0.0003,50,5"
response: "ok"
back to command list
9.1.1.23 Function Generators
Every function generator has the following ordered parameter set:
1. Frequency in Hz.
2. Initial phase angle in degrees.
3. Amplitude in %.
4. Offset in %.
5. Duty cycle in %.
Amplitude and offset, both in %, refer to the range of the piezoelectric voltage (in V) while the drift
compensation is inactive and refer to the range of the position (in µm, mrad or µrad) while the drift
compensation is active. The parameterized forms of the commands of the function generators initialize the
output only. The output starts after executing the command "
start,0,func ".
Note:
Even if a parameter is required in requests and contained in responses, it may be unused in the command
execution. An unused parameter is grayed out in the command-specific description.
back to command list
9.1.1.23.1 Command: sin
Command sin,frq,phase,amp,offs,duty
Description Set the parameters of the sine function generator by storing them into the device's EEPROM.
A running or stopped sine function generator is not affected.