phone: +49 (3641) 66880 • fax: +49 (3641) 668866 • [email protected] • http://www.piezojena.com
How to Operate the Voltage Amplifier
7
output current
10mA
output voltage
0 ... 130V
output connector
D-SUB 15
DAC resolution of the voltage output
16 Bit
ADC resolution of the measurement system 16 Bit
7.3 Initiation
When you open the package, please check to make sure that all the necessary parts are complete (see
packing list) and nothing is damaged.
Check the electronics and the actuator for any visible damage:
·
The top and bottom plate of the actuator (if it does not have another shape) should be parallel each to each
other, without scratches.
·
If there is any damage to the system please contact our local representative immediately!
·
If the packaging material is damaged please confirm this with the shipping company.
Before you switch on the system, please check:
·
The main voltage supplied in your country is the same as installed for the system (Check the voltage label
on the backside of the power supply adapter).
·
Connect the power supply adapter
.
·
Connect the piezoelectric actuator by using the D-SUB15pin connector. Be sure the cables are connected
properly to the electronics.
The nano box USB is controlled exclusively via the USB interface. The nano box USB uses two power
supplies. The first is via USB for the control unit and the second is an external 24V DC wide range power
supply for the high voltage output.
Connect the nano box USB using the included USB cable to the PC. The LED for monitoring switches to
permanent red.
If the USB driver has been installed already on the PC then the nano box USB is recognized by the operating
system. The LED for monitoring flashes green at wide intervals for about 0.5 seconds and then switches to
permanent green.
Otherwise, the USB driver has to be installed on the PC. The USB driver supports Windows XP, Windows
Vista and Windows 7 in the 32-bit and 64-bit versions respectively. The USB driver installation procedure is
described below where the steps for Windows 7 are the same for Windows Vista.
7.3.1 Installing the USB Driver (Windows XP)
The USB driver for the nano box USB can be downloaded from the website
www.piezojena.com
under
Downloads & Publications. Copy the driver file at32uc3xxx_cdcx32_64.inf to a directory of your choice. In
the example below the directory is D:\.
Connect the nano box USB with the PC using the supplied USB cable.
Windows shows the detection of the new hardware in the notification area of the taskbar:
After a short time, Windows opens the Found New Hardware Wizard: