Piazzetta P962, Инструкция по установке, использованию и техническому обслуживанию

Страница: 18 / 56

English
18 INSTALLATION
Instructions for redirecting heat
• The fan system which expels heat into the atmosphere is
equipped with two Y-shaped devices which effectively allow the
air flow to be doubled up, directing it via a flexible pipe to the
back of the stove from where it can then be directed into
adjoining rooms.
• Below are some examples of possible installations and examples
of how to redirect the hot air in order to heat other rooms. Such
examples are intended as demonstrations; optimum performance
depends in each case on conditions in the room where the stove
is installed and in the adjoining rooms.
it is of fundamental importance that when redirecting heat
from the rear of the stove the outlets and the Y-connector
are free of blockages to avoid overheating. In cases where
one rear outlet from the fan is to be employed, the outlet
must always be kept open.
• The examples give guidelines for redirection. Each diagram
represents only one solution of the many possible.
SOLUTION 1 - Fig. 31 - 32:
• the stove is installed in the room which is to be heated, with the heat
directed to the front only, as when the stove arrives from the factory
(fig 31). Alternatively the air can flow to the rear by connecting a 7.5
cm-diameter flexible pipe to the fan (fig 32). In this scenario the
stove heats the room where it is installed by radiation only, and
heats the adjoining room by means of redirection to the rear.
For the example shown in fig 32 it is necessary to use an
outlet which is permanently open.
SOLUTION 2 - Fig.33:
• The stove is installed in the room to be heated with the heat
directed to the front by one fan. A second fan directs to the rear
allowing the heating of a second room. A 7.5 cm-diameter flexible
pipe with a maximum length of 6 metres is connected to the fan’s
outlet (fig 33).
For the example shown in fig 33 the vent should be permanently
open.
DT2030216-00
Fig. 31
1 m
DT2030217-00
Fig. 32
Non-closable vents
6 m
DT2030218-00
Fig. 33
DT2030222-01 DT2030221-01
DT2030223-01
Fig. 28 Fig. 29
Fig. 30
deflectors
Non-closable vents