PIAGGIO 2005 XEVO 400ie, Руководство по ремонту

Страница: 291 / 376

020329Y Mity-Vac vacuum-operated pump
Locking torques (N*m)
System bleed calliper fitting: 12 ÷ 16 Nm
Front
- Remove the rubber hood from the bleed screw.
- Insert a rubber pipe in the bleed screw to permit
the brake fluid to be recovered.
- With the right-hand brake lever, load the system
and bring it up to the required pressure.
- Keeping the right-hand brake lever pulled, loosen
the bleed screw to purge the air. Then tighten the
bleed screw.
- Repeat the operation until only brake fluid comes out of the rubber pipe.
- Remove the fluid recovery pipe and refit the rubber cap over the bleed screw.
- Top up the brake fluid to the right level in the reservoir.
If necessary, bleeding can be done using a special vacuum pump
N.B.
DURING THE BLEEDING OPERATIONS, MAKE SURE THE BRAKE FLUID DOES NOT COME INTO
CONTACT WITH THE BODYWORK SO AS NOT TO DAMAGE IT. FURTHERMORE, DURING THE
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO OBSERVE THIS PRECAUTION WILL ENDANGER THE PROPER WORKING
AND EFFICIENCY OF THE BRAKING SYSTEM
Specific tooling
020329Y Mity-Vac vacuum-operated pump
Locking torques (N*m)
System bleed calliper fitting: 12 ÷ 16 Nm
- Repeat the operation for the other brake calliper.
Brake fluid level check
- Position the vehicle on a flat surface and on the
centre stand
- Remove the brake pump cover as indicated in the
photo
XEVO 400ie
Braking system
BRAK SYS - 291