PIAGGIO 2005 XEVO 400ie, Руководство по ремонту

Страница: 287 / 376

For fitting, position the disc correctly using the ar-
row stamped on it as reference.
- Do up the screws to the prescribed torque and
apply the recommended product
N.B.
THE ARROW STAMPED ON THE DISC INDICATING THE
RUNNING DIRECTION MUST BE FITTED TOWARDS THE
OUTSIDE OF THE VEHICLE.
Recommended products
Loctite 243 Medium strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Front brake disc mounting
5 ÷ 6 •
Disc Inspection
- These operations are described once but apply to both brake discs.
- Checking the disc is important; it must be perfectly clean, with no sign of rust, oil or grease or any
other dirt, and must show no signs of deep scoring.
Characteristic
New rear disc thickness
4.0 mm
Disc thickness at wear limit (front)
3.5 mm
- Using the appropriate tool, measure how much
the disc protrudes when the wheel is fitted prop-
erly. The protrusion, measured near the external
edge of the disc, must be less than 0.1 mm.
- If a value other than that prescribed is detected,
remove the front wheel and check how much the
disc protrudes. Maximum permissible out of true is
0.1 mm. If the value measured is greater, replace
the disc and repeat the check.
- If the problem persists, check and replace the
wheel hub if required.
XEVO 400ie
Braking system
BRAK SYS - 287