Philips DVDR730/00, Руководство пользователя

Страница: 154 / 158

72
PROBLEM SOLUTION
Other disc errors
(DVD+R), '
Disc
contains unknown
data
' interruption of a
recording (power
outage)
b
This message may appear if you instert a DVD+R that was not finalised or an error occurs during the
recording. DVD+R's that have not been finalised are very sensitive to fingerprints, dust, or dirt. This may
cause problems during recording.
To use the disc again, follow the next steps
1
Make sure that the surface of the disc is clean.
2
Open the disc tray with OPEN/CLOSE
J
. Insert the defect DVD+R but do not close
the tray .
3
Hold down
5
on the remote control until the tray closes. The disc will be read ('
READING
'
appears on the display) and the DVD recorder will start the repair process. This may take up
to four times as much time as the recording, in which the error occurred.
4
If the disc is recovered, the index screen will appear.
Please observe the following:
The recovering procedure is successfully only if there was a previous recording on the disc.
Error during recording: The title may be missing.
Error while changing the title/index picture: The original title/index picture may be visible.
Error while finalising: The disc appears not to have been finalised.
The index screen
flickers when a DVD+R
is inserted
b
You can finalise the disc using the following function:
1
Open the disc tray with OPEN/CLOSE
J
. Insert the defect DVD+R but do not close
the tray .
2
Hold down 4 on the remote control until the tray closes.
'
FINALIZE
' appears in the display. Finalising begins. This may take up to three minutes.
3
If finalising has been successful, the index screen will appear.
If I switch on a device,
connected to the
EXT2 AUX-I/O
socket,
the DVDRecorder
starts a recording.
b
The function 'Automatic Satellite Recording' is switched on.
If the DVD-Recorder is switched off, the symbol 'SAT' appears in the bottom left corner of the display.
If the DVD-Recorder is switched on, instead of the clock, '__:__' appears with a red background in the
'Tuner-Info-Field' (bottom left corner of the screen)
To switch off the function proceed as follows:
1
Press SYSTEM MENU .
2
Select with
B
the line ' Recordsettings ' (second menu page)
3
Select in line ' Sat record ' with
D
' Off ' instead of ' EXT2 '.
4
Confirm the change with OK .
5
End with SYSTEM MENU .
I have forgotten the
PINCode
b
To erase the PIN code (reset to 0000), proceede as follows:
1
First press
DISC MENU
then
SYSTEM MENU
.
2
Select the symbol ' A ' using
D
, select ' 1 (
Disc features
)' using
B
and confirm with
C
.
3
Confirm the line '
Access control
' using
C
and pree 4 times
STOP
h
on the remote
control. The PIN code is reset to '0000'.
4
End with SYSTEM MENU
Before you call an engineer