Making up styling parts
13 - 1
13
Making up styling parts
Style-dependent guide blades or work-holder bars are only required for
machines without angle-seam system.
13
.01
Making up guide blades for straight, single-pointed darts
●
Fit blank for guide blade on guide blade carrier.
●
Engage guide blade.
●
Mark needle centre on guide blade
(Fig. 13-01).
●
Disengage guide blade and take out blade.
●
Mark intersection "A" using two radiuses:
R1 = dart length ( AL ) + 7 mm
R2 = half dart length ( AT ) + 1.5 mm
●
Scribe outer contour of guide blade according to
Fig. 13-02
and cut out contour.
●
Apply two radiuses R 1 mm and R 0.5 mm as shown in
Fig. 13-03.
●
De-burr and polish cut edges.
●
Fit guide blade on guide-blad carrier.
●
Program dart 7 mm and position work-holder bar.
●
Carry out a sewing test.
●
If necessary adjust guide blade on eccentric pin.
Fig. 13 - 01
Intersection ”A”
Needle
centre
Blank for guide blade
95-752090-16
AL = dart length
AT = half dart length