10 - 16
Programming
Fig. 10 - 09
Fig. 10 - 10
●
Select the
INPUT
mode.
●
Press the
seam input key
(diode lights up)
●
Input the required program number.
●
Input the seam length, e.g. 35 mm (
Fig. 10-09
).
●
Input the stitch length.
●
Set the loading point at manual input
●
Input the loading point.
●
Input the starting point
●
Input a start backtack
●
Input stitch condensation at the end of seam.
A backtack at the seam end is only practical if the seam does not end outside
the material (e.g. as on straight pleats).
●
Input the enaging depth, e.g. 10 mm (for a 20 mm deep dart with a 10 mm deep guide
blade, see
Fig. 10-09
.
●
Input the angle seam length, e.g. 30 mm (
Fig. 10-09
).
●
Input the angle seam depth according to the preset amount, here 20 mm.
●
Specify the setting for the angle, e.g. accept preset amount by pressing enter
key (
Fig. 10-09
), or:
●
Increase the amount of the angle (
Fig. 10-10
).
To input a curved seam line the preset angle must be increased considerably
(seam test required).
●
The input seam pattern is accepted by selecting the
SEWING
mode.
20 mm
35 mm
30 mm
10
.06.03
Making waistband pleats