Pepperl+Fuchs HD2-DM-A, Руководство пользователя

Страница: 41 / 203

Advanced Diagnostics
Hardware Installation
2
02
0-
11
41
Figure 4.2 Cabinet installation example with Diagnostic Gateway
4.1.2 Device Address Assignment
Before mounting the module on the motherboard, a device address must be assigned to the
HD2-DM-A module. The address depends on your PCS infrastructure, see chapter 5 or see
chapter 6. This assignment is performed using the DIP switch on the device. The DIP switch
has 8 switches positioned next to each other. They can be used to assign addresses from
1 ... 247 in binary form.
Assigning the Device Address
In order to assign an address to the HD2-DM-A, proceed as follows:
Set each of the 8 DIP switches at the left side of the module in the correct position to generate a
unique address.
For more information on how to generate a binary address, see the label on the module.
The device address is assigned.
4.1.3 Connecting the PCS Connection
Depending on the used integration method, the following connections are required:
• FDS/OPC integration
An Ethernet RJ45 connector is located on the top of the diagnostic gateway. See chapter
3.3, see chapter 3.4.
• FF/H1 integration
FF-H1 connection is provided on the diagnostic gateway motherboard. See chapter 3.3,
see chapter 3.4. For some features, an additional Ethernet connection can be necessary,
see chapter 6.2.
ACC-MB-HDC link cable
LAST
MOTHERBOARD
LINK
This is used to
maintain loop
continuity at the
last motherboard
Diagnostic Gateway
Diagnostic Bus Line
Ethernet
Diagnostic Modules
Channel 1
Channel 2
+
-
Alarm
Note
Every HD2-DM-A module that is connected to the same KT-MB-GT2AD.FF* must have a
unique device address. See chapter 4.1.2