Patton electronics SmartWare R.3.20, Руководство по настройке программного обеспечения

Страница: 93 / 573

Basic system management configuration task list
93
SmartWare Software Configuration Guide
7 • Basic system management
Mode: Administrator execution
Example:
Displaying the
checksum of a configuration
The following example shows how to display the checksum of the configuration test of your device, if you start
from the configuration mode.
node#show crc nvram:test
File nvram: test:
checksum: 0xfaddc88a
Configuration of terminal sessions
In certain cases it may be desirable to change the settings of the current terminal session.
Mode: System
When there are many VoIP units in the same location, use this command to flash all the LED’s on a specific
unit for a specified period of time. This makes identification of the physical unit very easy.
Step Command Purpose
1 node#show crc
filename Displays checksum of a configuration
Step Command Purpose
1 [
name
] (sys)#terminal height
Configures the terminal height.
2 [
name
] (sys)#[no] terminal idle-time-
logout
After 30 minutes without user input, a terminal session
is automatically closed. If longer session periods are
required (logging/debugging) this command allows
to increase the session timeout, or to disable it com-
pletely.
3 [
name
] (sys)#terminal more
Enables pausing of display for commands which pro-
duce more output than the current terminal window
can display at once.
4 [
name
] (sys)#terminal width
Configures the terminal width.
Step Command Purpose
1 [
name
] #blink <seconds>
Enter an integer for the period of time you want the
LED’s to flash on the physical unit.