![background image](http://html1.mh-extra.com/html/patton-electronics/smartware-r-3-20/smartware-r-3-20_software-configuration-manual_4044387509.webp)
VoIP profile configuration task list
509
SmartWare Software Configuration Guide
40 • VoIP profile configuration
Configure codecs
The VoIP profile contains a list of codecs the forms the set of allowed codecs that can be used to set up a VoIP
connection. The list is assembled in order of priority (i.e. the first entered codec is the most preferred one). For
each codec in the list, a set of parameters can be configured.
Procedure:
Add a codec to the list (this procedure is valid for all other codecs as well).
Note
If you press the
<tab>
key after entering a few letters of a configuration com-
mand, the full command name will display or a listing of commands that
begin with those letters will display. Press the
<enter>
key to select the
desired command.
Signaling protocols have a codec negotiation mechanism, it is not
guaranteed that the first codec in the list is used to set up the con-
nection. Each codec in the list may be used. To make sure that
only one codec is possible, configure this codec alone. See how
to display the currently configured codecs in a VoIP profile on
page 522
.
The default VoIP profile contains the codecs G.711uLaw and
G.711aLaw. If you don’t want to use these, you must explicitly
remove them from the list.
IMPORTANT
IMPORTANT
Содержание SmartWare R.3.20
Страница 553: ...553 Appendix A Terms and definitions Chapter contents Introduction 554 SmartWare architecture terms and definitions 554...
Страница 559: ...559 Appendix B Mode summary Chapter contents Introduction 560...
Страница 566: ...566 Appendix D Internetworking terms acronyms Chapter contents Abbreviations 568...
Страница 571: ...571 Appendix E Used IP ports available voice codecs Chapter contents Used IP ports 573 Available voice codecs 574...