Patton electronics SmartWare R.3.20, Руководство по настройке программного обеспечения

Страница: 430 / 573

Call router configuration task list
430
SmartWare Software Configuration Guide
33 • Call router configuration
Example: Create a hunt group service
This example shows how to configure the hunt group service as shown in figure 61 on page 423.
node(cfg)#context cs
node(ctx-cs)[switch]#service hunt-group HUNT-BRI
node(func)[HUNT-BRI]#cyclic
node(func)[HUNT-BRI]#timeout 6
node(func)[HUNT-BRI]#route dest-interface IF-BRI0
node(func)[HUNT-BRI]#route dest-interface IF-BRI1
node(func)[HUNT-BRI]#route dest-interface IF-BRI2
node(func)[HUNT-BRI]#route dest-interface IF-BRI3
Protocol Error
(Cont.)
ie-does-not-exist
Drop original call The remote equipment receives a message
that includes information elements or call
properties that are not recognized.
invalid-ie-contents
Drop original call The remote equipment receives a message
that includes invalid information in the
information element or call property.
recovery-on-timer-
expiry
Drop original call Your call was not completed, probably
because an error occurred.
protocol-error
Drop original call An unspecified protocol error with no
other standard cause occurred.
Interworking
interworking Drop original call An event occurs, but the network does not
provide causes for the action it takes. The
precise problem is unknown.
Table 16. Hunt group drop causes (Continued)
Class Cause
Default Behavior
of the Hunt
Group Service
Description