Patton electronics SmartWare R.3.20, Руководство по настройке программного обеспечения

Страница: 185 / 573

T1/E1 port configuration task list
185
SmartWare Software Configuration Guide
15 • T1/E1 port configuration
mode is immediately entered. To remove an existing channel-group the ‘no’ form of the command has to
be used.
Mode: port e1t1 <slot> <port>
Configuring Channel-Group Timeslots
The ‘timeslots’ command configures an arbitrary sequence of timeslots for use in data transmission. The syntax
of the command accepts comma-separated groups of timeslots. A group can be a single timeslot or a range of
timeslots. The channel-group timeslots do not have to be contiguous. The ‘no’ form of the command releases
all previously selected timeslots.
Example:
>timeslots 1,4,6 Selects three timeslots (1, 4 an 6)
>timeslots 1,4-6 Selects four timeslots (1, 4, 5 and 6)
>timeslots 1-3,4-6 Selects six timeslots (1, 2, 3, 4, 5 and 6)
Mode: channel-group group-name
Configuring Channel-Group Encapsulation
In the channel-group configuration mode only the encapsulation type ‘hdlc’ is available. For more details see
‘Configuring T1/E1 Encapsulation’.
Mode: channel-group group-name
Entering HDLC Configuration Mode
The hdlc configuration mode can be entered either from the “port T1/E1” configuration mode or from the
“channel-group” configuration mode. If you cannot enter the hdlc mode, it may be due to an invalid or incom-
plete configuration, and an error message will be issued. In “port T1/E1” configuration mode, you only need to
set the encapsulation for ‘hdlc’ in order to enter the hdlc configuration mode. In “channel-group” configura-
Step Command Purpose
1 [
name
] (prt-e1t1)[
slot/port
]#[no] channel-
group group-name
Enters the channel-group configuration mode of
group-name. If the group does not yet exist a new
one will be created. The ‘no’ form of the command
removes an existing channel-group.
Step Command Purpose
1 [
name
] (ch-grp)[
group-name
]#[no]
timeslots
timeslots
Selects the timeslots to be used.
Default:
no timeslots
Step Command Purpose
1 [
name
] (ch-grp)[
group-name
]#[no] encap-
sulation hdlc
Specifies the encapsulation type of the channel-
group. Default:
no encapsulation