Patton electronics NetLink 2960 RAS, Руководство по началу работы

Страница: 36 / 69

3 • Configuring the RAS for operation Model 2960/2996 RAS Getting Started Guide
36 Configuring the RAS with a Web browser
From the Home page, the following actions can be performed:
• Record Current Configuration —clicking on this button ( figure 20 ) causes the current configuration to be
stored in FLASH memory. Any changes made to the RAS configuration are stored in non-volatile RAM
first. This allows the user to set the box up with a working configuration before committing it to FLASH.
Configuration changes become permanent when you select
Record Current Configuration . You will lose all
changes not stored to FLASH the next time the RAS is re-booted.
Figure 20. Immediate Actions buttons
• Hard Reset —this button ( figure 20 ) causes the RAS to perform a cold restart. When you select Hard Reset ,
the RAS confirms that you want to execute this command. Then, the RAS will disconnect all current ses-
sions, re-initialize the interfaces, and re-load configuration parameters from FLASH.
• Set Factory Default Configuration —this button ( figure 20 ) clears out the configuration in FLASH and
loads the factory default parameters into FLASH memory. The factory default settings will not execute on
the RAS until it is re-booted.
Note Set Factory Default Configuration ( figure 20 ) will delete any routing
information, the RAS’s Ethernet IP address, and any other site spe-
cific settings made for your particular installation. You will have to re-
enter the RAS’s Ethernet IP address and netmask using the front
panel control port in order to use the HTTP/HTML Manage-
ment pages.