Patton electronics NetLink 2960 RAS, Руководство по началу работы

Страница: 26 / 69

2 • Hardware installation Model 2960/2996 RAS Getting Started Guide
26 Cable installation
Connecting the 10/100Base-T Ethernet port to an Ethernet-capable workstation
The 10/100Base-T Ethernet port can connect to a single Ethernet-capable workstation by means of a cross-
over cable. Refer to
figure 10 to assemble a cross-connect cable that will connect between the NIC Ethernet
port in the workstation and the RAS 10/100Base-T Ethernet port.
Figure 10. Cross-over RJ-45-to-RJ-45 Ethernet cable diagram
Connecting the EIA-561 RS-232 configuration port
Install the supplied DB-9-to-RJ-45 cable between the RAS RS-232 port (see figure 8 on page 25) and an open
serial port on your computer. If you need to assemble your own cable, refer to the pinout diagram in figure 11 .
Figure 11. DB-9-to-RJ-45 cable diagram
Connecting to the T1/E1/PRI WAN ports
An active T1/E1/PRI is not necessary to configure the RAS. However, an active T1/E1/PRI connection is required
to receive or make calls. The factory-set default configuration of the access server has the T1/E1 ports disabled.
Note The cable connecting the T1/E1/PRI WAN ports to the RJ-48C ter-
mination jack should be CAT-3 or higher and extend no farther than
1 mile (1.6 km) from the digital services termination.
10Base-T Workstation
RJ-45 Pin No.
RAS 10/100Base-T Port
RJ-45 Pin No.
(TX+)
(TX-)
(RX+)
(RX-)
1
2
3
6
(RX+)
(RX-)
(RX+)
(TX-)
3
6
1
2