Cable installation
25
Model 2960/2996 RAS Getting Started Guide
2 • Hardware installation
Connecting the Ethernet ports
The RAS has a single 10/100 Ethernet interface for connection to your LAN (see
figure 8
). The Ethernet port
will autosense the correct speed of the local LAN and automatically negotiate half- or full-duplex operation.
This section describes connecting the RAS to the Ethernet LAN via an Ethernet hub, switch, or workstation.
Figure 8. Model 2960/2996 network and configuration ports
Connecting the 10/100Base-T Ethernet port to an Ethernet switch or hub
The 10/100Base-T Ethernet port (see
figure 8
on page 25) is designed to connect to an Ethernet switch or
hub. Connect a straight-through CAT-5 cable (one wired as shown in
figure 9
) between the RAS and the hub/
switch.
Figure 9. Straight-through RJ-45-to-RJ-45 Ethernet cable diagram
10/100
ETHERNET
RS-232
CONFIG
T1/E1/PRI WAN PORTS
1
2
3
4
EXPANSION MODULE
Содержание NetLink 2960 RAS
Страница 6: ...Contents Model 2960 2996 RAS Getting Started Guide 6...
Страница 12: ...About this guide Model 2960 2996 RAS Getting Started Guide 12...
Страница 28: ...2 Hardware installation Model 2960 2996 RAS Getting Started Guide 28 Completing the hardware installation...
Страница 52: ...3 Configuring the RAS for operation Model 2960 2996 RAS Getting Started Guide 52 Completing the installation...