Parker Compumotor 6200, Руководство по установке

Страница: 36 / 45

Appendix A
L V D I n s t a l l a t i o n I n s t r u c t i o n s
When installed according to the procedures in the main body of this installation guide (pages 2-21),
the 6200 may not necessarily comply with the Low Voltage Directive (LVD). To install the 6200 so
that it is LVD compliant, following the instructions provided in this appendix. If you do not follow
these instructions, the protection of the 6200 may be impaired.
For more information about the Low Voltage Directive (LVD), see 73/23/EEC and 93/68/EEC,
published by the European Economic Community (EEC).
Environmental Conditions
Pollution Degree: The 6200 is designed for pollution
degree 2.
Installation Category: The 6200 is designed for
installation category II.
Electrical
Connecting & Disconnecting Power Mains
The 6200’s protective earth connection is provided through
its make-first/break-last earth terminal on the power mains
connector. You must reliably earth the 6200’s protective
earth connection. Attach or remove the 6200’s power plug
only while input power is OFF.
Changing Power Cords
You must provide a LVD-approved 240V AC power cord if
your 6200 is to be operated from a 240VAC power mains.
Power supplies in the 6200 are rated for operation at both
120V and 240V, nominal. The 6200 is shipped with a
standard 120V UL-rated cord, because it is not feasible to
accommodated the variety of power mains connector
configurations found in the European Community.
Compumotor provides in the ship kit a mating connector for
6200 AC input power connector which can be attached to your
LVD-approved 240V AC power cord.
WARNING —
Do not modify the 120V AC
power cord shipped with the 6200 for use with 240V AC
power mains. This will violate the LVD stipulations
regarding the use of properly rated parts.
Mechanical
Installing in an Enclosure: The 6200 must be installed
within an enclosure. The enclosure’s interior must not be
accessible to the operator. The enclosure should be opened
only by skilled or trained service personnel.
Servicing the 6200
Changing Firmware: Only skilled or trained personnel
should change firmware.
Changing Batteries: The 6200 contains a replaceable
lithium battery, of type Duracell DL2450, or Sanyo CR2450,
or equivalent. Only skilled or trained personnel should change
batteries. Dispose of batteries in accordance with local
regulations.
Do Not Replace Fuses: The 6200 has no fuses designed
to be replaced by the user. Fuse failure indicates that other
components have also failed. Fuses and other components
should only be replaced by Compumotor or its designated
repair facilities.
Table of Symbols & Warnings
The following symbols may appear in this manual, and may
be affixed to the products discussed in this manual.
Symbol Description
Earth Terminal
Protective Conductor Terminal
Frame or ChassisTerminal
Equipotentiality
Caution, Risk of Electric Shock
Caution, Refer to Accompanying Text
Recycle Battery
Hot Surface
BATTERY
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com