Par T Golf Double Eagle Elite Plus 4, Руководство по установке и обслуживанию

Страница: 8 / 72

PAR T GOLF DOUBLE EAGLE INSTALLATION AND MAINTENANCE MANUAL
THE DOUBLE EAGLE ELITE SECTION A A4
ELECTRICAL POWER REQUIREMENTS
Each Double Eagle should receive power from a dedicated 15-ampere circuit, 110 volt circuit (220V where
applicable) to operate properly and safely. Power should be delivered from the circuit breaker to the outlet boxes
using grounded, No. 12-2 or No. 10-2 Romex™ wire. A transformer is recommended in areas with higher
voltage, or where a dependable power source is not available.
CAUTION: ALL ELECTRICAL LINES SHOULD BE INSTALLED BY A LICENSED ELECTRICIAN.
1.
A dedicated 15-ampere circuit, with
105 to 125 volts, RMS 60 Hz AC
(220V, 50Hz where applicable). – The Double Eagle is designed to operate in a range of 105 to 125 volts
(220V where applicable) of consistent power. One dedicated 15-ampere
circuit should be available to sustain the simulator's peak draw.
2. Use No. 12-2 or No. 10-2 grounded
Romex™ wire. –
Always follow local electrical codes, however, No. 12-2 or No. 10-2
size, grounded, Romex™ wire should be used between the circuit
breaker and the electrical boxes.
3. Use a transformer, where voltage is
higher, or power is not stable. – If a dependable power source is not available, a constant-voltage
harmonic-neutralized transformer must be used to power the entire
system. Though not required where a stable source of power exists,
such a transformer, supplying a constant 110 volts (220 V where
applicable) of power will greatly extend the life of lamps in the unit.
4. Component Wattage
–
Control Console 0.5 Amp ( 50W @120V)
Optisense™ 10.4 Amp (1,250W @120V)
Video Projector 2.0 Amp ( 250 W @120V)
TOTAL 12.9 Amp (1550 W @120V)
LOCATION OF ELECTRICAL SWITCHES AND OUTLETS
IMPORTANT: Place a power switch near the control console. This switch will be used daily as you
start and stop play on the simulator. It is recommended that power to the Optisense and to the control
console be controlled by this switch. Also install a separate switch for the projector (the location is at
your discretion). Always shut the projector off according to the procedure outlined in the projector’s
manual. Failure to do so will result in premature failure of the lamp assembly.
During the platform construction phase of the installation, three electrical outlet boxes and power switches should
be installed by your electrician as indicated in Drawing 2B. Also see Drawing 2B
Wiring Detail in this section
for recommendations on the location of the power switches and the outlet boxes.