Par T Golf Double Eagle Elite Plus 4, Руководство по установке и обслуживанию

Страница: 12 / 72

PAR T GOLF DOUBLE EAGLE INSTALLATION AND MAINTENANCE MANUAL
SECTION B THE PLATFORM
B1
INSTALLING ELECTRICAL CONNECTIONS AND CABLES
IMPORTANT: ALL ELECTRICAL LINES SHOULD BE INSTALLED BY AN ELECTRICIAN.
STEP 5
Install power switches
–
Near the control console, place power switches that effect power to the
Optisense, control console and projector. The projector should be placed
on a separate power switch. (Note: Do not turn projector off without
letting the lamp cool. Refer to projector manual for proper on/off
procedure).
STEP6 Install box # 1 for control
console –
Locate AC duplex box #1 near the front right-hand corner of the platform,
as shown in Figure 3
STEP 7 Install box # 2 for overhead
Optisense
Drawing 2B
–
Electrical box #2 should be mounted in the ceiling if possible. It should
be located in the center of the platform (left to right) and 10’ 7” (3226
mm) from the screen end of the platform. This will be directly above the
overhead Optisense™ when installed.
STEP 8 Install box # 3 for the video
projector –
Electrical box #3 should be mounted in the ceiling if possible. It should
be located in the center of the platform (left to right) and 19’ (5791 mm)
from the screen end of the platform. This will be directly above the video
projector when installed.
ATTACHING THE PLYWOOD
STEP 10 Attach plywood to the platform –
For best results, start at the screen end of the platform, and use
wood screws and construction adhesive.
Figure 3 & 4 – IMPORTANT! Keep the plywood pieces removed for the
Tri Turf cut-out, they are used in step 12.
CUTTING OUT THE BALL CUP HOLE
STEP 11 Size and location of ball cup
hole
–
The ball cup hole is 4 ¼” (108 mm) in diameter.
Figure 3 – The ball cup hole is located in the center of the platform, left to
right (it is important that the cup be exactly in the center), and
approximately 36” (914 mm) from the screen-end of the
plywood (exact distance from end of plywood is not as critical).
_