Par T Golf Double Eagle Elite Plus 4, Руководство по установке и обслуживанию

Страница: 41 / 72

PAR T GOLF DOUBLE EAGLE INSTALLATION AND MAINTENANCE MANUAL
SECTION E ENJOYING YOUR SIMULATOR E3
C
hapter
10
A
IMING AND
C
ALIBRATING THE
C
AMERA
NOTE: You will need: (i) a six foot ladder; (ii) a measuring tape; (iii) a white golf ball ; (iv) two black No. 10 wood
screws; (v) a white business card; and (vi) the allen-wrench/screw driver tool (provided).
Each of the three cameras must be properly and independently aimed in order to give an accurate reading of the golf ball's
flight. Each camera is mounted to the Optisense with three adjustment socket head cap screws. The camera angle can be
adjusted by gently turning one or more of these adjustment screws with the special allen-wrench/screw driver tool provided.
To aim the cameras: (i) establish three targets, one for each camera, then (ii) independently aim each camera at its target.
After all of the cameras are accurately aimed, they are said to be in alignment. The cameras will get out of alignment
periodically. To realign them, follow the steps in this section.
NOTE: Although the cameras do not require any focusing, you will need to occasionally adjust the amount of light they
receive. This is referred to as the camera's "sensitivity".
AREA SET-UP
STEP 1 Mark the three Calibration
points –
In order to align the cameras, you must first locate the three calibration
points (targets) on the putting surface.
Locate Calibration Points
#1 and #2
Drawings 10A & 10B –
Using your measuring tape, locate two points on the Putting Turf
immediately in front of the Tri-Turf. Both points are in the center (side
to side) of the platform. The first point is 6” (152 mm) in front of the
Tri-Turf. The second point is 32” (813 mm) in front of the Tri-Turf.
Mark Points #1 and #2
with a black screw – At each point, insert a black, #10 wood screw, recessed 1/4 inch below
carpet surface. These screws mark Calibration Point #1 and Calibration
Point #2.
Drawing 10A Set-Up for Aiming Cameras