Par T Golf Double Eagle Elite Plus 4, Руководство по установке и обслуживанию

Страница: 46 / 72

PAR T GOLF DOUBLE EAGLE INSTALLATION AND MAINTENANCE MANUAL
SECTION E ENJOYING YOUR SIMULATOR E7
–
If you determined that the camera line is on the screen side of
Calibration Point #2, turn adjustment screw #1 counter-clockwise.
Turn opposite direction if it is on the Tri-turf side of Calibration Point
#2.
–
Continue turning screw #1 in the same direction, until the camera line
aligns with Calibration Point #2. Again, your indication that the placed
object is in the line of sight of the camera is the graphical represention
on the screen.
Aim Middle Camera
left to right – Left to right aiming adjustments for the cameras are made by turning
either screw #2 or screw #3.
Drawing 10C
–
Insert allen-wrench/screwdriver tool into either Screw #2 or Screw #3,
and turn slowly in a clockwise direction.
– If message numbers go further away from 256, stop and adjust the
other screw in a clockwise direction.
– Once you have determined which screw to adjust, continue turning
clockwise as numbers approach 256.
NOTE: If the graphical image and the calibration numbers disappears from the screen, it means that the
camera is no longer properly aimed front-to-back. This is easily corrected by turning screw #1 as was
described earlier.
–
Continue alternating adjustments of screw #1 then either (not both)
screw #2 or screw #3 until the message reads
“ 256”
Congratulations! Camera #2 is now properly aligned.
STEP 6 Aim Camera #3 (Closest to
the screen) – Place a white business card on Calibration Point #3. Position ladder
approximately 2 feet closer to the screen and slightly right of center.
Be sure the ladder is not in the camera's field of vision.
NOTE: Aiming camera #3 requires a slightly different procedure.
Aim Far Camera at
Calibration Point #3
–
With business card on Calibration Point #3, climb the ladder, and while
looking upward into the Optisense locate screws #1 for camera #3
–
Slowly turn screw #1 clockwise for up to 5 full turns. If camera #3 has
not detected the business card at Calibration Point #3, then turn Screw
#1 counterclockwise, until it does.
Drawing 10C
–
_
Now, slowly turn either screw #2 or screw #3, until the message on the
screen read
“256”
Congratulations! The camera #3 is now properly aligned.