Panasonic YD-400VP1YHD, Руководство по эксплуатации

Страница: 126 / 154

8. Various settings
WMD078TE0PAA07
126
8.10.5 DIRECT
A function that allows you to perform simple set-
tings by allocating specific setting items, such as
frequently used setting items, to its submenus.
Setting items that can be allocated to DIRECT
(* Submenu numbers no in use are ignored.)
Submenu # Setting item Setting range Increment Default
DETAIL mode
“Weld parameter”
0 RUN-IN SPEED -50 to 50 1 0
1 HOT VOLTAGE -50 to 50 1 0
2 FTT LEVEL -99 to 99 1 0
3 BURNBACK TIME -99 to 99 1 0
4 PENETRATION -30 to 30 1 0
5 PRE-FLOW TIME 0.0 to 10.0 0.1 0.2
6 POST-FLOW TIME 0.0 to 10.0 0.1 0.5
7 PULSE PEAK CUR -99 to 99 1 0
8 PULSE BASE CUR -99 to 99 1 0
9 PULSE RISE CUR -30 to 30 1 0
10 PULSE FALL CUR -30 to 30 1 0
11
WFS FINE ADJ
(*1) -50 to 50 1 0
13 WAVE CONTROL 1 -99 to 99 1 0
14
PULSE FREQ
(*2)
-99 to 99 1 0
17 PULSE WIDTH -99 to 99 1 0
18
CRATER DC 0: Invalid
1: Valid - 0
19
INIT PLS DC 0: Invalid
1: Valid
- 0
20
LOW PULSE SET 0: Invalid
1: Valid
2: Automatic
(*3)
- 0
21 LOW PULSE CUR 30 to 400 2 120
22 LOW PULSE VOL 5 to 50 0.2 20.2
23 LOW PULSE FREQ 0.5 to 10 0.1 2.0
24 LOW PULSE DUTY 10 to 90 5 50
25 LOW PULSE DELAY 0 to 9.9 0.1 0
30 DISPLAY TIME 1 to 30 1 5
32
PENET INC 0: Invalid
1: Valid
2: Automatic - 2
(*1) The same setting item as “WIRE-FEED ADJUST” in SET button.
(*2) Not adjustable if material is set to either “AL-HARD (
Hard aluminum
)” or “AL-SOFT (
Soft aluminum
)”.
(*3) Not adjustable if “2: AUtomatic” is selected ” as “LOW PULSE DELAY” in this setting becomes “0”.