6.58
CHAPTER 5
C
USTOMIZING THE
S
YSTEM
STARTING UP
S
TART
-
UP
S
EQUENCE
Before starting the VPS, make sure all installation and line connections have been done as described in
Chapter 2.
Turn the power switch to ON. The calls to the VPS can be processed after the Power Light stops flashing.
.
After turning the power on, the system starts up in the following sequence:
1. The Power Indicator light goes on.
2. The Power Indicator light begins to flash.
3. “CARD TEST” is displayed on the screen.
4. “SYSTEM SETUP” is displayed.
Screen Output:
CARD TEST...
SYSTEM SETUP...
1.. 2.. 3..
5. The VPS tests the CPU card, the hard disk drive, and the CO cards
as “SYSTEM SETUP...” is displayed.
6. Active ports are displayed on the screen.
Screen Output:
Active COs: 1 2 3 4
DPITS Interface Connection is Established
** ON LINE MODE **
The display will alert you if System Setup is not completed successfully.
Screen Output:
Active COs: 1 2 3 4
DPITS Interface Connection is not Established
** OFF LINE MODE **
Содержание KXTVS100 - VOICE MAIL SYSTEM
Страница 12: ...6 12...
Страница 13: ...6 13...
Страница 72: ...6 72 Delayed Answer 0 60 sec 0 Specifies whether the port answers immediately or in delay...
Страница 77: ...6 77...