Panasonic KXTVS100 - VOICE MAIL SYSTEM, Быстрое руководство по установке

Страница: 60 / 91

6.60
Possible causes of this message are listed below:
Cause Action
The PBX is not a KX-TD series system.
Since the default PBX type for the KX-
TVS100 is set to KX-TD1232 at the
factory, this message will
always appear
when connecting to another type of PBX.
Change the PBX type by using
Quick Setup (see below).
The cabling between the PBX extension
ports and the VPS is not four-wire or is
improperly connected. Confirm the cabling is connected as
described in Chapter 2.
The PBX is a KX-TD series but does not
have the proper level of software required
to support D-PITS Integration. Contact Panasonic Parts Center
(MSC) at 1-800-833-9296
or use Inband Integration under
hardware settings.
The PBX is not programmed properly to
support D-PITS Integration. Do required integration
programming as described in
Chapter 3.
Start-up completed:
1. The Power Indicator light stops blinking when the start-up has been successful.
(The delay varies according to the system’s condition.)
2. “**ON LINE MODE**” is displayed.
3. System prompt > is displayed on the screen.
To enter system administration, press ENTER.
When the system administrator starts operation, the system asks for the terminal type. By choosing VT100
[2], all parameters can be set through the menu driven program.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100 COMPATIBLE TERMINAL
ENTER THE NUMBER := ______
Q
UICK
S
ETUP
Quick Setup provides a quick way to set the following programming items. Each of these must be initially set
to start the VPS operation.
1. PBX type
2. Extension numbers of VPS ports
3. Extension numbers for mailboxes
4. Creating mailboxes
5. Port service setting
6. Password setting