Panasonic KX-T336, Справочное руководство системы

Страница: 749 / 1605

6-F-3
3.00 Call Park-System
Description
This function provides putting a call into the
parking place common to the whole system.
Up to 20 calls can be parked with each call park
area number (01 to 20).
CALL-PARK key should be assigned as
programmable key in advance.
Parked call can be retrieved from any extension
in the system.
Programming
Reference
VT Dumb
“System-Tenant”, Call Park
Boundary
System Programming
9-D-2.00 10-C-5.00
Attendant Management Reference
6-C-10.00
CALL-PARK key
Conditions
A call on the DES side of the LOOP key can not
be parked.
In case of no answer in preassigned time, Held
Call Reminder starts.
For further detail, refer to Section 3-E-2.00 “Held
Call Reminder.”
In case of no answer in 30 minutes after starting
hold, the held party is disconnected.
If Tenant Service is employed, 20 parking areas
can be split between two tenants in “System-
Tenant”, Call Park Boundary. In this case, each
tenant cannot use the other's parking place.
If music source is connected to the system, Music
on Hold (such as radio) is sent to the parked
party. For sending Music on Hold, prior
assignment is necessary by programming.
Refer to Section 3-E-1.00 “Music on Hold.”
Operation
Parking a call
During a conversation with an extension or
outside party,
1. Press the CALL-PARK key
(programmable key).
• The call is held.
• The SRC indicator starts
flashing in green 60 wink, the
DES indicator is lit, dial tone
sounds.
2-1 To park the call to an idle
parking area: Dial “
*
.”
• The call is parked in an idle
parking area. After
confirmation tone sounds, it
becomes silent.
• Both SRC, DES indicator lights
on the LOOP key go out.
• The following message appears
on the message line:
Message : Call parked at xx
xx: parking area number (01 to
20)
2-2 To park a call by specifying a
parking area number: Dial the
parking area number: 01 to 20.
• Results is the same as dialing
“
*
” key.
(Supplement)
Busy tone sounds if all the parking areas or a
specified parking area are occupied.
The following message appears on the message
line of CRT.
If all the parking areas are in use:
Message: Call park deny
CALL PARK