Panasonic KX-T336, Справочное руководство системы

Страница: 1438 / 1605

1.01 INS (In Service) Command
Description
Changes the status of the target device (shelf,
card, port, station etc.) to “In Service” in on-line
communication mode.
Conditions
The status of the specified devices (shelf, card,
port, station) should be “OUS” or “FAULT.”
When you change the status of a lower device
(port, station) to “INS,” the upper device (shelf,
card) should be changed to “INS” status
beforehand.
If you try to change the lower device (port,
station) status to “INS” while upper device (shelf,
card) is in “OUS” status, the error message
“Invalid Status” appears on the screen.
Operation
Press the function key INS.
Enter the number of the desired device.
For input values, see below:
CMD> In Service No. = xxxxxx
1 2 3
Device
Shelf
Card
Port
Station
ATT
DTMF
CNF
Input Value
1 to 3 (physical number)
101 to 315 (physical number)
1011 to 3158 (physical number)
DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
A1 or A2 or
Physical number: four digits
Rxxxy (xxx:Card number; y: 1 or 2)
CFBxx or CFOyy (xx: 01 to 08,
yy: 01 to 64)
Refer to Section 14-F “Functional Test by
Entering Commands” for details about test
command.
When you change the status of an upper device,
the status of lower devices changes as follows.
Upper device OUS INS
Lower device OUS INS
Fault Fault
Upper device Fault INS
Lower device Fault INS
OUS OUS
Normal operation
The following message appears on the screen.
***** OK
Operation failed
An error message appears on the screen in the
following cases.
• Parameter error
• Not installed
• Status error
• INS failure (Diagnostic error)
14-C-2