Panasonic KX-T336, Справочное руководство системы

Страница: 1534 / 1605

C. Device Status
1.00 Service Commands and
Their Functions
1.01 INS (In Service) command
Description
At the operation prompt (OPE>), enter INS
command to change the status of the target
device (shelf, card, station etc.) to “In Service” in
on-line communication mode.
Command Format
OPE>INS + Item No.
(Item)
Refer to Section 15-E-3.00 “TST Command
(Test)” for details about test command.
Conditions
The status of specified devices (shelf, card,
station) should be in “OUS” or “FAULT,” and
system must be in on-line mode.
When you change the status of a lower device
(port, station) to “INS,” the upper device (shelf,
card) should be in “INS” status.
If you try to change the lower device status to
“INS” while upper device is in “OUS” status, the
error message “Invalid Status” appears on the
screen.
Device
Shelf
Card
Port
Station
ATT
DTMF
CNF
Input Value
1 to 3 (physical number)
101 to 315 (physical number)
1011 to 3158 (physical number)
DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
A1 or A2 or
Physical number: four digits
Rxxxy (xxx:Card number; y: 1 or 2)
CFBxx or CFOyy (xx: 01 to 08,
yy: 01 to 64)
When you change the status of an upper device
(shelf, card), the status of lower devices (port,
station) change as follows.
Upper device OUS INS
Lower device OUS INS
Fault Fault
Upper device Fault INS
Lower device Fault INS
OUS OUS
Normal operation
When this operation is executed without failure,
initial “OPE>” prompt appears again on the
screen.
Operation failed
The error message appears on the screen in the
following cases.
• Parameter error
• Not installed
• Status error
• INS failure (Diagnosis error)
15-C-1