3. Allocating the PC Link Area Using Programming Tools
The PC Link Area can be allocated by setting system registers. System register setting is performed with the FP
Programmer II or the NPST-GR programming support tool.
Using the FP Programmer II
The tools to be prepared : FP Programmer II
:AFP1114, (or FP Programmer : AFP1112A or AFP1112)
FP Peripheral Cable :AFP5520(0.5m) or AFP5523(3m)
1. Connect the FP Programmer II to the RS422 port on the CPU using the FP Peripheral Cable.
2. Set the CPU to the PROG. mode.
Note:
3. Set the system registers in the CPU using the OP50 function and the following procedure;
•Link relay(L)
•Link data register(LD)
• If the AFP1112 type FP Programmer is used, the baud rate must be set in at the CPU.
Be sure to set the baud rate in the CPU to 19,200.
4-2.P/W PC Link
33
P/W PC LINK 0
P/W PC LINK 1
Description
System register 40
50
Link relay(L) area size setting
number
42
52
Starting address for the send relay link area
43
53
Send relay link area size
P/W PC LINK 0
P/W PC LINK 1
Description
System register 41
51
Link data register(LD) area size setting
number
44
54
Starting address for the send data link area
45
55
Send data link area size
ACLR
(–)
OP
5
0
ENT
READ
(HELP)
CLR
(BIN)
K/H
WRT
Enter the system register number.
Enter the new value for the specified system register address.
The set value of the spacified register address is displayed.
