Panasonic ELC500, Руководство пользователя

Страница: 193 / 208

ELC500 Control unit
185
■
Demand control by using wireless device
Condition Cause Action to take
Demand value is not
correct. Registered points are too much and
it can’t communicate correctly. Reduce the registered points of each device.
Multiplier or digit is not matched.
Check multiplier or digit for each device.
Command can’t be
sent by wireless
communication It doesn’t support protocol of
wireless device. Check the protocol of wireless device is
matched to using communication protocol.
Command can be sent,
but no response is
received.
Wait time for sending or timeout is
too short.
Set transmission interval 100ms or more.
Data has a gap. Time-out time is short. Set time-out time 3-sec or more for 1 master or
repeater.
Ex.) Master 1 unit + Repeater 2 units
Time-out time should be 10-sec or more.
■
FTP
Condition Cause Action to take
Cannot connect via
FTP Ethernet cable is disconnected. Connect Ethernet cable correctly.
Connected IP address is not
correct. Check IP address at Basic configuration.
Security function is enabled. Cancel security function or use PASV mode.
Setting port for FTP is used by
another function. Check the setting port can be used or not.
Cannot login User name or password is not
correct. Check the user name and password.
If you forget the password, set password again
at the user registration.
Another user logs in. After a while, access again.
Although a connection is
established, it fails in the file
operation.
(such as that a list is not
displayed.)
FTP tool software used is not
supported. Use another FTP tool software or FTP
pre-installed in Windows (operate by command
prompt) for file operation.